CADDY2K.com

Decided to do the VW badge gloss black and wrap the backing the same colour as the van

Can anyone tell me what I've done to my tailights. They don't light up in the E pattern anymore. This is a genuine mk4 but I have been messing around with some coding so I'm not sure what I have done

Sent from my SM-G988B using Tapatalk

Winter wheels fitted today
BBS SR 17x7.5J ET45 with 235/45/17 tires

R8umar wrote: ↑Thu Dec 17, 2020 3:24 pm Decided to do the VW badge gloss black and wrap the backing the same colour as the van

Can anyone tell me what I've done to my taillights. They don't light up in the E pattern anymore. This is a genuine mk4 but I have been messing around with some coding so I'm not sure what I have done

Sent from my SM-G988B using Tapatalk

Did you do an Auto-Scan and did you save it before you changed the coding? if so revert back to the old code by going into the log and copy and paste it into the new coding box found in the coding section of the correct module if that makes sense? then start again

First mod to my van couldn’t resist as it came off a 2019 seat and was a bargain at £25 squids thanks silverlake


Sent from my iPhone using Tapatalk

Gave it a well needed wash !

Deanopolini, that's a lovely van.

I have to agree with you there Dean


Sent from my iPhone using Tapatalk

Tidy


Sent from my iPhone using Tapatalk

R8umar wrote: ↑Thu Dec 17, 2020 3:24 pm Can anyone tell me what I've done to my tailights. They don't light up in the E pattern anymore. This is a genuine mk4 but I have been messing around with some coding so I'm not sure what I have done

Strange, AFAIK there's no way to do this via coding. Needs a EEPROM edit via VCP..

Today cluster replace, Caddy 2K 2005

Old:


"New":

caddychris2002 wrote: Did you do an Auto-Scan and did you save it before you changed the coding? if so revert back to the old code by going into the log and copy and paste it into the new coding box found in the coding section of the correct module if that makes sense? then start again

I did it using obdeleven. It had a history mode so I should have my original coding there I'll give that a go. Thanks

Sent from my SM-G988B using Tapatalk

@anonymous hi, I did try revert back to original but it didn't fix anything. I'm sure where it says new software version I may have tapped that and uploaded a newer version. Could that be the problem?

Sent from my SM-G988B using Tapatalk

R8umar wrote: ↑Fri Dec 18, 2020 2:24 pm @anonymous hi, I did try revert back to original but it didn't fix anything. I'm sure where it says new software version I may have tapped that and uploaded a newer version. Could that be the problem?

Possibly. I don't know anything about whatever app you're using, where it gets software updates from or what applying them does to your vehicle. You need to edit the BCM configuration EEPROM and write it back to BCM. AFAIK the only software that can do that is VAGCANPro.

Here is a post I made on the edits that would need to be done:

viewtopic.php?f=6&t=40406

I 've fitted the low level sensor for screen wash bottle... i just have to try pin 17 on cluster and coding.

@R8umarwhereareyoulocated mate, I have VCP sure I can help you out.