Does it have box section pieces up inside the chassis rails?
2013 Caddy with EA888 Gen3 2.0TSI DSG, Superplus MSP19 , Caddy4 rear lights, Polo GTI (mk7 style) steering wheel, Relentless Tuning front coilovers, Audi A6 S-Line front seats, Boxster fronts & GTI rear Brakes, 3D Colour Premium dash cluster, Caddy life arm rest, Motexion bulkhead, MIB head unit
All posts written by me are the intellectual property of the caddy2K forum and I do not consent to copying or redistribution of any sort
Yet another oil change, just because it's so simple with the sump drain plug.
Done at DubUnit as always.
2013 Caddy with EA888 Gen3 2.0TSI DSG, Superplus MSP19 , Caddy4 rear lights, Polo GTI (mk7 style) steering wheel, Relentless Tuning front coilovers, Audi A6 S-Line front seats, Boxster fronts & GTI rear Brakes, 3D Colour Premium dash cluster, Caddy life arm rest, Motexion bulkhead, MIB head unit
All posts written by me are the intellectual property of the caddy2K forum and I do not consent to copying or redistribution of any sort
pete3dmunds wrote: ↑Wed Sep 30, 2020 10:07 pm
Fitted these to the van today... Any ideas what they are for
Sent from my Pixel 2 using Tapatalk
Does anybody have the part number for these coat hanger brackets for the b pillar trims?
I have the actual coat hangers but require these brackets that bolt to the shell, I’ve searched everywhere for a part number to no avail....
Thanks in advance
Thanks for that, that’s also helped, when I got the b pillar bulkhead delete trims used in the caddy Kombi it baffled me how the coat hangers attached. The parts guy at VW van Centre took the coat hangers off a factory kombi to look and this had the brackets but my standard maxi didn’t.
I’ve come to learn that there are subtle differences in the shell between variants.
One set of the tie down hooks in a maxi are in a different place to the maxi kombi, only by a couple of inches. I noticed this when I ordered the factory kombi rear rubber floor and the cutouts are in a different place for 2 of the hooks.
Finished polishing up the kill all wipers back window delete but still not happy with it..some light scratches still. Not the easiest to photograph.. Anyone any advice to get a good finish cause once it's bonded it's in!
@J_con make sure you check that before you fit it. With all that paint and adhesive not sure it will fit flush. You might need to sand back the edge. So it fits a bit more flush.