Cadz09 wrote:That head liner looks smart, what did you use, dye or spray? I just had to replace my lower side runner too, alot easier then I expected it to be.
Sprayed the headlining with cheap satin black and trimmed the shelf with some material
Was going to head out to the Bottle bank to get rid of all her empty bottles of Pinot Grigio and then a clean
Van hasn’t liked sitting for 3 weeks Battery flat as a you know what, and my jumper pack also
Sent from my iPad using Tapatalk
Chestnut Brown Caddy MK4 Maxi Life 2.0Tdi 150bhp , 18” Matt Bronze OZ Ultraleggera’s 8Jx18 ET45 on Bridgestone 225/40/18’s
Chaps
Need some advice. Charged the car and have taken for a spin, and all good. I now have engine light on ? It’s not misfiring, any ideas please ? Is this due to battery going completely flat perhaps ?
Cheers for some advice
Sent from my iPad using Tapatalk
Chestnut Brown Caddy MK4 Maxi Life 2.0Tdi 150bhp , 18” Matt Bronze OZ Ultraleggera’s 8Jx18 ET45 on Bridgestone 225/40/18’s
@Ripley55 hi mate, my battery has died a few times and never had the engine light come on, mine has been on ever since I overfilled the adblue last time though lol
Ahh @gazza31112
Strange coincidence, as 3 weeks ago I filled up with Adblue as well, and may have put a drop too much in as well, but didn’t notice a light afterwards, and obviously haven’t been anywhere, can it just be cleared on ignition, or is it VCDS scan and reset ?
Chestnut Brown Caddy MK4 Maxi Life 2.0Tdi 150bhp , 18” Matt Bronze OZ Ultraleggera’s 8Jx18 ET45 on Bridgestone 225/40/18’s
I tried to clear mine but it just comes back, apparently from what I have read the sensor needs recalibrating, you can only refill the amount it says on the dash, I just filled until it overflowed, which apparently confuses the sensor.
Not certain of this, it's just what Iv read.
I haven't bothered to get it checked as my warranty has just run out lol, Iv got a fault code of failure to read NOX sensor b, I assume that's something to do with adblue, but still runs fine.
Sent from my J8210 using Tapatalk
Last edited by gazza31112 on Sun May 17, 2020 12:23 pm, edited 1 time in total.
[mention]Ripley55 [/mention] The sensor may need replacing or resetting/ recalibrated. From what I’ve heard if you delete the fault code it just comes back. If it’s to do with the NOx sensor that is.